Top Cisco 300-410 Courses Online - Updated [Sep-2022]
300-410 Practice Dumps - Verified By Actual4Exams Updated 395 Questions
You can read the Best Solution to prepare Cisco Certified Specialist - Enterprise Advanced Infrastructure Implementation (300-410) Exam
If you are preparing for CCENT certification, then Cisco 300-410 exam dumps is the perfect solution for you. It will help you to understand the basic networking knowledge required for the preparation of CCENT certification exam. Practice questions for CCENT exam help you to understand the topics. Major topics covered by Cisco CCENT certification are networking. Leaders in online instruction for the preparation of CCENT exam is available for you. Sample exam of CCENT certification is available for you. Studying material for CCENT exam questions is available for you. Studying material for CCENT certification exams is available for you. Windows operating system is required to check the validity of Cisco 300-410 certification exam questions. The Cisco CCENT exam questions and answers are available for free study. Actual4Exams offers the CCENT (300-410) exam certification to the students at lowest cost. The Cisco CCENT (300-410) certification is widely demanded in IT industry. Purchase the best study guide for CCENT exam. CCNA certification is not sufficient to meet the current needs of Networking Industry. Implementing the CCENT certification is the only way to make you more marketable. Guide for CCENT certification is available for you. Valid version of CCENT exam is available for you.
You can prepare for CCENT exam by using the best study material. Requirements of the CCENT certification are available for you, cisco's CCENT certification should be your goal. Features of the CCENT certification are available for you. Passing the CCENT exam is only half the work of getting a job. Best practice are followed to prepare questions for the CCENT exam. Networking exams are updated on regular basis.
NEW QUESTION 79
Refer to the exhibit.
What does the imp-null tag represent in the MPLS VPN cloud?
- A. Exclude the EXP bit
- B. Pop the label
- C. Impose the label
- D. Include the EXP bit
Answer: B
Explanation:
The -imp-null (implicit null) tag instructs the upstream router to pop the tag entry off the tag stack before forwarding the packet.
Note: pop means -remove the top MPLS label
NEW QUESTION 80
An engineer is trying to copy an IOS file from one router to another router by using TFTP.
Which two actions are needed to allow the file to copy? (Choose two.)
- A. Enable the TFTP server on the source router with the tftp-server flash:<filename> command.
- B. Copy the file to the destination router with the copy tftp: flash: command
- C. Configure a user on the source router with the username tftp password tftp command.
- D. TFTP is not supported in recent IOS versions, so an alternative method must be used.
- E. Configure the TFTP authentication on the source router with the tftp-server authentication local command.
Answer: A,B
NEW QUESTION 81
An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?
- A. set ip next-hop
- B. set ip next-hop verify-availability
- C. set ip default next-hop
- D. set ip next-hop recursive
Answer: C
Explanation:
NEW QUESTION 82
Refer to the exhibit.
An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen. What is the reason for this?
- A. The syntax of the static route is not valid, so the route is not considered.
- B. The metric of the OSPF route is lower than the metric of the static route.
- C. The configured AD for the static route is higher than the AD of OSPF.
- D. Dynamic routing protocols always have priority over static routes.
Answer: C
Explanation:
The AD of static route is manually configured to 130 which is higher than the AD of OSPF router which is 110.
NEW QUESTION 83 
- A. snmp-server group NETADMIN v3 priv read NETVIEW write NETADMIN access 22
- B. snmp-server group NETVIEW v2c priv read NETVIEW access 20
- C. access-list 20 permit 10.221.10.11
- D. access-list 20 permit 10.221.10.12
Answer: C
NEW QUESTION 84
Refer to the exhibit.
An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the summary route does not show up in the routing table. Why is the summary route missing?
- A. The summary route is not visible on this router, but it is visible on other OSPF routers in the same area.
- B. There is no route for a subnet inside 10.0.0.0/8, so the summary route is not generated.
- C. The summary route is visible only in the OSPF database, not in the routing table.
- D. The summary-address command is used only for summarizing prefixes between areas.
Answer: D
NEW QUESTION 85 
Refer to the exhibit. Which action restores the routes from neighbors while still filtering 1.1.1.0/24?
- A. Add a second line in the access list to permit any.
- B. Add a second sequence in the route map permit 20
- C. Modify the route map to permit the access list instead of deny it
- D. Modify the access list to deny instead of permit it.
Answer: C
NEW QUESTION 86
Refer to the exhibit.
Which statement about R1 is true?
- A. OSPF redistributes RIP routes only if they have a tag of one
- B. RIP routes are redistributed to OSPF without any changes
- C. R1 adds one to the metric for RIP learned routes before redistributing to OSPF
- D. RIP learned routes are distributed to OSPF with a tag value of one
Answer: D
NEW QUESTION 87
Refer to the exhibit.
After redistribution is enabled between the routing protocols, PC2, PC3, and PC4 cannot reach PC1.
Which action can be engineer take to solve the issue so that all the PCs are reachable?
- A. Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.
- B. Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.
- C. Set the administrative distance 100 under the process on R2.
- D. Redistribute the directly connected interfaces on R2.
Answer: B
NEW QUESTION 88
Refer to the exhibit.
AS65510 iBGP is configured for directly connected neighbors. R4 cannot ping or traceroute network 192 168.100.0/24 Which action resolves this issue?
- A. Configure R4 as a route reflector server and configure R2 and R3 as route reflector clients.
- B. Configure R1 as a route reflector server and configure R2 and R3 as route reflector clients
- C. Configure R4 as a route reflector server and configure R1 as a route reflector client
- D. Configure R1 as a route reflector server and configure R4 as a route reflector client
Answer: C
NEW QUESTION 89
Refer to the exhibit.
Redistribution is enabled between the routing protocols, and nowPC2 PC3, and PC4 cannot reach PC1. What are the two solutions to fix the problem? (Choose two.)
- A. Filter RIP routes back into RIP when redistributing into RIP in R2
- B. Filter OSPF routes into RIP FROM EIGRP when redistributing into RIP in R2.
- C. Filter all routes except EIGRP routes when redistributing into OSPF in R3.
- D. Filter RIP AND OSPF routes back into OSPF from EIGRP when redistributing into OSPF in R2
- E. Filter all routes except RIP routes when redistributing into EIGRP in R2.
Answer: A,C
NEW QUESTION 90
Refer to the exhibit.
When monitoring an IPv6 access list, an engineer notices that the ACL does not have any hits and is causing unnecessary traffic to pass through the interface Which command must be configured to resolve the issue?
- A. access-class INTERNET in
- B. ip access-group INTERNET in
- C. ipv6 access-class INTERNET in
- D. ipv6 traffic-filter INTERNET in
Answer: D
NEW QUESTION 91
Refer to the exhibit.
After a security audit, the administrator implemented an ACL in the route reflector. The RR became unreachable from any router in the network. Which two actions resolve the issue? (Choose two.)
- A. Remove the ACL entry 80.
- B. Configure a link-local address on the Ethernet0/1 interface.
- C. Enable the ND proxy feature on the default gateway.
- D. Permit ICMPv6 neighbor discovery traffic in the ACL.
- E. Change the next hop of the default route to the link-local address of the default gateway.
Answer: B,D
NEW QUESTION 92
Refer to the exhibit.
An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?
- A. Configure the service timestamps log datetime localtime command in global configuration mode.
- B. Configure the service timestamps log uptime command in global configuration mode.
- C. Configure the logging clock synchronize command in global configuration mode.
- D. Make sure that the clock on the device is synchronized with an NTP server.
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/xr12000/software/xr12k_r3-9/system_management/command/reference/yr39xr12k_chapter4.html#wp1784026936 By default, syslog and debug messages are stamped by UTC, regardless of the time zone that device configured. You should append localtime key word to "service timestamp {log | debug} datetime msec" global command to change that behavior.
https://community.cisco.com/t5/networking-documents/router-log-timestamp-entries-are-different-from-the-system-clock/ta-p/3132258
https://www.cisco.com/E-Learning/bulk/public/tac/cim/cib/using_cisco_ios_software/cmdrefs/service_timestamps.htm
NEW QUESTION 93
What command disables 802.1x authentication on a port and permits traffic without authentication?
- A. dot1x port-control force-authorized
- B. dot1x port-control disable
- C. dot1x port-control auto
- D. dot1x port-control force-unauthorized
Answer: A
Explanation:
The command dot1x port-control force-authorized is used to disable 802.1x on a port and permit traffic without authentication. Dot1x ports are in one of two states, authorized or unauthorized. Authorized ports permit user traffic to flow through the port. This state usually follows successful authentication. Unauthorized ports only permit authorization traffic to flow through the port. Usually a port begins in the unauthorized state. A user is then allowed to exchange AAA authentication traffic with the port. Once the user has been authenticated successfully, the port is changed to the authorized state and the user is permitted to use the port normally.
Normal use of 802.1x has the port configured with the dot1x port-control auto statement. This places the port in the unauthorized state until successful authentication. After successful authentication, the port is changed to the authorized state.
When 802.1x is initially configured, the default port control of the ports is force-authorized. This forces the port to be in the authorized state without successful authentication. This setting disables the need for authentication and permits all traffic.
The force-unauthorized keyword configures the port as an unauthorized port regardless of authentication traffic.
A port configured with this key word would not permit user traffic, not even authentication traffic.
The command dot1x port-control disable is not a valid command due to incorrect syntax.
Objective:
Infrastructure Security
Sub-Objective:
Describe device security using Cisco IOS AAA with TACACS+ and RADIUS
References:
Cisco > Catalyst 6500 Series Release 15.0SY Software Configuration Guide > Security > IEEE 802.1X Port- Based Authentication Cisco > Catalyst 4500 Series Switch Cisco IOS Command Reference, 12.2(52)SG > aaa accounting dot1x default start-stop group radius through instance > dot1x port-control Cisco > Catalyst 4500 Series Switch Cisco IOS Command Reference, 12.2(52)SG > aaa accounting dot1x default start-stop group radius through instance > dot1x port-control
NEW QUESTION 94
How are MPLS Layer 3 VPN services deployed?
- A. The RD and RT values must match under the VRR
- B. The RD and RT values under a VRF must match on the remote PE router
- C. The import and export RT values under a VRF must always be the same.
- D. The label switch path must be available between the local and remote PE routers.
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/iosxr/ncs5500/vpn/65x/b-l3vpn-cg-ncs5500-65x/b-l3vpn-cg-ncs5500-
NEW QUESTION 95
......
New (2022) Cisco 300-410 Exam Dumps: https://braindumps.actual4exams.com/300-410-real-braindumps.html