2024 Updated Verified 350-401 dumps Q&As - Pass Guarantee or Full Refund
350-401 PDF Questions and Testing Engine With 775 Questions
Validity of 350-401 Exam
- It is valid for 03 years. These three years start from the date of issue. An annually updated Version can be purchased.
If you failed in 350-401 Exam, don't worry. Cleared in the previous exams, we guarantee you in the next exams. We will provide the dump with the updates. This is very important for the IT industry and many people do not know about it. Corrected candidates should apply to Pearson VUE for re-examination.
The vendor will contact the candidates for re-examination within two to four weeks. Update announcement will be released online. Luck and hard work. All the best for your future. If you are connected to hard duties and too much busy to take the exam. You will be happy to know that you can take the exam anytime in an annual; in Jan, Feb, Mar, Apr, Jun, Jul, Aug, Sep, or Oct. I suggest you take the exam in the morning; in a fresh mood.
NEW QUESTION # 332
What mechanism does PIM use to forward multicast traffic?
- A. PIM sparse mode uses receivers to register with the RP.
- B. PIM sparse mode uses a flood and prune model to deliver multicast traffic.
- C. PIM dense mode uses a pull model to deliver multicast traffic.
- D. PIM sparse mode uses a pull model to deliver multicast traffic.
Answer: D
NEW QUESTION # 333
Refer to the exhibit.
The IP SLA is configured in a router. An engineer must configure an EEM applet to shut down the interface and bring it back up when there is a problem with the IP SLA. Which configuration should the engineer use?
- A. event manager applet EEM_IP_SLA
event sla 10 state unreachable - B. event manager applet EEM_IP_SLA
event track 10 state down - C. event manager applet EEM_IP_SLA
event sla 10 state down - D. event manager applet EEM_IP_SLA
event track 10 state unreachable
Answer: B
Explanation:
The -ip sla 10 will ping the IP 192.168.10.20 every 3 seconds to make sure the connection is still up. We can configure an EEM applet if there is any problem with this IP SLA via the command -event track 10 state down.
NEW QUESTION # 334
Refer to the exhibit.
An engineer must ensure that all traffic leaving AS 200 will choose Link 2 as the exit point. Assuming that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers, which configuration accomplish task?
- A. R4(config-router)nighbor 10.2.2.2 weight 200
- B. R4(config-router)bgp default local-preference 200
- C. R3(config-router)bgp default local-preference 200
- D. R3(config-router)neighbor 10.1.1.1 weight 200
Answer: B
NEW QUESTION # 335
Which two methods are used to interconnect two Cisco SD-Access Fabric sites? (Choose two.)
- A. wireless transit
- B. SAN transit
- C. IP-based transit
- D. fabric interconnect
- E. SD-Access transit
Answer: C,E
NEW QUESTION # 336
Which two characteristics define the Intent API provided by Cisco DNA Center? (Choose two.)
- A. northbound API
- B. business outcome oriented
- C. southbound API
- D. device-oriented
- E. procedural
Answer: A,B
Explanation:
NEW QUESTION # 337
Drag and drop the characteristics from the left onto the orchestration tools that they describe on the right.
Answer:
Explanation:
NEW QUESTION # 338
Which IPv6 migration method relies on dynamic tunnels that use the 2002::/16 reserved address space?
- A. GRE
- B. 6RD
- C. ISATAP
- D. 6to4
Answer: D
Explanation:
6to4 tunnel is a technique which relies on reserved address space 2002::/16 (you must remember this range). These tunnels determine the appropriate destination address by combining the IPv6 prefix with the globally unique destination 6to4 border router's IPv4 address, beginning with the
2002::/16 prefix, in this format:
2002:border-router-IPv4-address::/48
For example, if the border-router-IPv4-address is 64.101.64.1, the tunnel interface will have an IPv6 prefix of 2002:4065:4001:1::/64, where 4065:4001 is the hexadecimal equivalent of
64.101.64.1. This technique allows IPv6 sites to communicate with each other over the IPv4 network without explicit tunnel setup but we have to implement it on all routers on the path.
NEW QUESTION # 339
Refer to the exhibit.
Refer to the exhibit. Which command set must be added to permit and log all traffic that comes from 172.20.10.1 in interface GigabitEthernet0/1 without impacting the functionality of the access list?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: C
NEW QUESTION # 340
Refer to the exhibit.
An engineer must block all traffic from a router to its directly connected subnet 209.165.200.0/24. The engineer applies access control list EGRESS in the outbound direction on the GigabitEthernetO/O interface of the router However, the router can still ping hosts on the 209.165.200.0/24 subnet. Which explanation of this behavior is true?
- A. After an access control list is applied to an interface, that interface must be shut and no shut for the access control list to take effect.
- B. Access control lists that are applied outbound to a router interface do not affect traffic that is sourced from the router.
- C. The access control list must contain an explicit deny to block traffic from the router
- D. Only standard access control lists can block traffic from a source IP address.
Answer: B
NEW QUESTION # 341
Refer to the exhibit.
A network engineer configures a new GRE tunnel and enters the show run command. What does the output verify?
- A. The tunnel destination will be known via the tunnel interface
- B. The default MTU of the tunnel interface is 1500 byte.
- C. The tunnel keepalive is configured incorrectly because they must match on both sites
- D. The tunnel will be established and work as expected
Answer: A
NEW QUESTION # 342
An engineer is implementing a Cisco MPLS TE tunnel to improve the streaming experience for the clients of a video-on-demand server. Which action must the engineer perform to configure extended discovery to support the MPLS LDP session between the headend and tailend routers?
- A. Configure the interface bandwidth to handle TCP and UDP traffic between the LDP peers
- B. Configure an access list on the interface to permit TCP and UDP traffic
- C. Configure a Cisco MPLS TE tunnel on both ends of the session
- D. Configure a targeted neighbor session.
Answer: C
NEW QUESTION # 343
Running the script causes the output in the exhibit. Which change to the first line of the script resolves the error?
- A. from ncclient import*
- B. from ncclient import
- C. import manager
- D. import ncclient manager
Answer: A
NEW QUESTION # 344
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
- A. weight, AS path, local preference, MED
- B. local preference, weight, AS path, MED
- C. local preference, weight MED, AS path
- D. weight, local preference, AS path, MED
Answer: D
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External > IGP Cost > eBGP Peering > Router ID
NEW QUESTION # 345
Drag and drop the characteristics from the left onto the correct routing protocol types on the right.
Answer:
Explanation:
Explanation
OSPF: SEGMENT, LINK STATE, TABLES
EIGRP: UNEQUAL PATH, DISTANCE VECTOR, METRIC
NEW QUESTION # 346
Which reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?
- A. mismatched OSPF network type
- B. mismatched MTU size
- C. mismatched areas
- D. mismatched OSPF link costs
Answer: B
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-
12.html#neighbors
NEW QUESTION # 347
......
Exam Engine for 350-401 Exam Free Demo & 365 Day Updates: https://braindumps.actual4exams.com/350-401-real-braindumps.html